UNASSEMBLED PARTS
|
| Mower | Mower Front Wheel | |
(5) | Large Retainer |
|
|
|
| Springs - 7/16 | (1) 3/4 O.D. Washers |
|
|
|
|
|
| |
|
|
| (1) Wheel |
|
|
|
|
| (1) |
(2) | Smaller Retainer |
|
|
|
| Springs - 5/16 |
|
|
|
|
|
| (1) Shoulder Bolt | (1) Locknut |
|
| (3) | ||
|
|
|
| |
(1) |
|
|
| |
|
|
| (1) Oil Drain Tube | Slope Sheet |
|
|
| For Future Use |
|
|
|
| Keys |
|
| (2) Rear Lift Link |
|
| |
| Assemblies |
|
| |
|
|
| (2) Keys |
|
|
| ASSEMBLY |
| |
Your new tractor has been assembled at the factory with ex- ceptionofthosepartsleftunassembledforshippingpurposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(2) | 7/16" wrenches | Utility knife |
(1) | 1/2" wrench | Tire pressure gauge |
(1) | 3/4" wrench | Pliers |
(1) | 3/4" socket w/drive ratchet |
|
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
BEFORE REMOVING TRACTOR FROM SKID
TO CHECK BATTERY (See Fig. 1)
•Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at
•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton .
•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.
•Remove mower and packing materials.
•Check for any additional loose parts or cartons and
remove.5
LABEL |
Fig. 1
