Husqvarna 961430104 TO ASSEMBLE GRASS CATCHER See Fig, INSTALL STARTER ROPE See Fig, Assembly

ASSEMBLY

TO ASSEMBLE GRASS CATCHER (See Fig. 3)

1.Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top.

2.Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using.

FRAME

HANDLE

VINYL	FRAME
BINDINGS	OPENING

FIG. 3

INSTALL STARTER ROPE (See Fig. 4)

1.Loosen T-knob.

2.Place throttle control in STOP position.

3.Slowly pull engine starter rope out until rope will slip into loop of rope guide.

4.	Tighten T-knob.
		THROTTLE CONTROL
		“STOP” POSITION
	ROPE GUIDE	T-KNOB
		ENGINE
		STARTER
		ROPE
		FIG. 4

TO INSTALL ATTACHMENTS

Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see “TO CONVERT MOWER” in the Operation section of this manual.

5