ASSEMBLY
6TRIMMING MIDDLE CHUTE
1.Using the hacksaw, trim along the dashed line.
2.Locate the middle chute, flat washer, hood latch, weld nut, lock washer and machine screw from kit.
3.Install in the appropriate hole at the upper end of the middle chute, according to deck size.
7INSTALLING BAGGER MOUNT
1.Using hardware provided in kit, attach support mount to unit.
2.Attach hanger bracket to support mount. Do not fully tighten nuts at this time.
Machine Screw
Hood Latch
Weld Nut
Lock Washer
Flat Washer
Latch Location
Trim Line
Support Mount
Hanger Bracket
3.Secure rear end of support straps to outside of hanger assembly. Set reinforcement plates to the outside of the tank brackets and fasten front end of support strap to tank bracket and reinforcment plate with round head bolt. Secure front end
of reinforcement plate to tank bracket with hex bolt. Fully secure all mounting hardware. See illustration.
NOTE: Rear guard hole may need to be drilled out to 5/16" if kit hardware is too large.
7INSTALLING MIDDLE CHUTE
1.Place middle chute over the top end of the blower assembly.
2.Latch middle chute to blower assembly.
Middle Chute
Blower Assembly
Hex Bolt Placement
Round Head
Bolt Placement
Reinforcement Plate
Support Straps
10
