11
1. Position upper chute support against bagger inlet,
ushatouteredges.SeeIllustration.
2. Using support as a template, drill two 3/8 holes into
bagger hood.
Upper Chute Support
Bagger Inlet
Nut
Bagger Hood
Flat Washers
Hex Bolt
Flex Trim
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
ASSEMBLY
8INSTALLING CHUTE SUPPORT
3½ Bolt
WeightBracket
Weight Assembly
1. Boltcastweighttoweightbracketsusing3/8-16 x 3
bolts and four nuts.
2. Slidebothweightbracketsoverthefronttubeon
the frame. Be sure to position the weight assembly
in the center of the frame.
3. Secure with 3/8-16 x 3½ bolts and four nuts.
Front Tube
9INSTALLING WEIGHT KITS
3" Bolt
CAUTION

DO NOT operate mower with grass

catcher without front weights installed.

10MOUNTING COVER ASSEMBLY

NOTE: Assistance from another person may ease

mounting the cover assembly to mower.

1. Liftandrotatecovertoalignthecoverbrackets
with support assembly tubes.
2. Slide the cover down over the support tubes until
secure.