8
1. Removethedischargechutefromthedeck.(Deck
congurationwillvarybysizeandmodel)
2. Lowerdecktothelowestcuttingposition.
3. Removetherighthand(dischargeside)beltcover
fromthedeck.
4. Relievethetensionfromthedeckbeltandremove
fromthecenterdeckpulley.
(SeeOperator’sManualifnecessary)
ASSEMBLY
1INSTALLING DRIVE PULLEY 2MOUNTING BLOWER ASSEMBLY
Outer Pulley Cover Pin
Hairpin Cotter
RearMountBracket
Contact Area
5. Removethenutsecuringtherighthanddeck
pulley to the spindle.
6. Installdrivepulleyincludedincollectionsystemkit
ontopofthecurrentdeckpulley.
7. Reinstall the nut on the spindle and torque to 55-
75 ft/lbs.
8. Reinstallthedeckbelt.
DeckHeight
Adjustment
Belt Cover
Discharge Chute
Drive Pulley
1. Position blower over the discharge tabs on the
deckandsetblowerontothedeck.
2. Besuretheblowerissittingushagainstthe
outsideofthedeck.
3. Installthefrontmountbrackettothedeckwiththe
pinandhairpincottersuppliedwiththekit.