Husqvarna BZ6134D manual Replacing the Fuel Filter, Checking Tire Pressures, Maintenance, Radiator

MAINTENANCE

Replacing the Fuel Filter

The fuel filter is located with the priming pump. Replace the fuel filter every 800 hours (once per season) or more regularly if it becomes clogged.

Replace the filter as follows:

Unscrew fuel filter from pump and replace.

Every 50 hours check for water in the fuel filter. Empty if necessary. Refer to the engine manual.

Checking Tire Pressures

All four tires shall have a pressure of 16 PSI.

Check and Filling Coolant System

WARNING!

ALWAYS make sure the engine is stopped and cool before removing radiator pressure cap. To prevent scalding by hot fluid, NEVER remove the radiator cap while engine is hot

NOTE: Failure to follow the recommended procedure for filling the cooling system will cause engine overheating and possible engine failure.

ALWAYS check coolant level at the overflow reservoir. The correct level of coolant in the over flow tank does NOT assure the radiator is full.

It is extremely important that when antifreeze is used, that it be mixed with water in a separate container before adding. NEVER add straight antifreeze to the radiator. Recommended mix is 50/50 lowtox phosphate-free antifreeze with tap water.

Refer to engine operator’s manual.

The radiator for this cooling system is provided with two drain valves; one at each end of the lower tank. When draining the

PRIMING PUMP

FUEL FILTER

Fuel filter and fuel pump BAM-18

8011-564

Tire pressures

Radiator BAM-19

33