Husqvarna 968999216, 968999218, BZ7234D Operation, Important Information, Engaging the mower deck

OPERATION

3.Select the cutting height by placing the pin in one of the holes. Lock the pin on the inside with the cotter pin.

4.Press in the stop handle, counter hold, and carefully move the lifting lever forward from the transport position toward the pin on manual units.

5.On power units push the hydraulic lift switch forward to lower the deck to the selected pin position.

IMPORTANT INFORMATION

The mower deck’s anti-scalp rollers should be evenly adjusted. See Maintenance section

WARNING!

Make sure that no one is near the machine when engaging the mower deck.

8011-561

Cutting height selection (27.5 HP )

6.Engage the mower deck by pulling out the control knob.

7.The machine’s speed and direction are continuously variable using the two motion control levers. The motion control levers can be moved forward or backward about a neutral position. Furthermore, there is a neutral position, which is locked if the motion control levers are moved outward into the neutral slots.

When both controls are in the neutral position (N), the machine stands still.

The motion control levers on each side of the mower control the direction of movement. The left lever controls the flow of oil from the left hydro pump to the left wheel motor. The right lever controls the flow of oil from the right hydro pump to the right wheel motor.

NOTE: To begin motion, the operator must be in the seat and the parking brake disengaged

Hydraulic switch

Engaging the mower deck

BAM-2

BAM-2

24