BP4E
5. Set up
Hose clamps are not completely tight. Please tighten hose clamps prior to using. Hose clamps are left loose to extend life of gaskets and fittings.
Oil cap gasket before using and lubricate weekly so the gasket will seal properly and prevent chemical leaks.
Oil check valve and keep breather hole clear of debris. Your failure to oil may cause the tank to collapse
and crack due to vacuum created by pump lubricate with “3 and 1” oil.
Make sure to insert the locking pin for the pump handle in its (only) CORRECT POSITION.
Fig. 1
The pin limits the pump stroke for optimum performance.
Observe Fig. 1 exactly. (Fig. 2 and 3 spell trouble.)
For best results and to maintain a good
Fig. 2 seal, re-grease piston sleeve periodically with vaseline or similar light lubricants.
HOW TO ASSEMBLE
1.Attach spray wand to spray gun and tighten firmly.
2.Take pump handle RMKIT 7 and insert into the tube on the pump lever RMKIT 5 (“T” shape lever on sprayer), you will notice holes drilled through both sides of both the pump handle and the pump ever. Align these holes, take the “R” pin provided and place through the holes. This affixes the handle in place and is ready for use.
For storage reverse process and then place “R” pin through the pump lever
RMKIT to keep from losing “R” pin.
3.Instructions for installing shoulder strap plastic buckle:
First put the sprayer on a hard flat surface, take the white plastic buckle and while holding the sprayer up slightly, place buckle under the tubular metal frame. Slowly push down forcing the frame into the buckle. Repeat the same procedure for other side.
Fig. 13
