ASSEMBLY
4 MOUNTING COVER ASSEMBLY TO
TRACTOR (See Fig. 4)
Use Hardware - - GROUP "C"
NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting assembly to tractor.
•Raise seat on tractor to allow assembly to be mounted.
•With cover closed, lift assembly and place support post inside mounting bracket. Allow assembly to rest on lanced tabs of mounting bracket.
•Line up holes in mounting bracket with holes in support post and insert bracket support pin. Secure with retainer spring.
•Unlatch and open cover.
•Install the three (3) tubing end caps onto container support.
•Tap each end cap onto container support tubes to seat securely.
BRACKET | COVER ASSEMBLY | |
SUPPORT PIN | ||
|
RETAINER
SPRING
END CAP
SUPPORT POST
5 | CONTAINER ASSEMBLY (See Fig. 5) |
No hardware required |
•Place bottom half inside of top half, as shown.
•Place one foot inside bottom half and lift top half to meet bottom half.
•Press halves tightly together while lifting top to lock into place as shown.
IMPORTANT: BEFORE LOCKING THE TABS, HOOKED EDGES ON BOTH HALVES MUST OVERLAP TO FORM SEAL AS SHOWN IN INSET.
•Repeat for second container.
CONTAINER
BOTTOM
HALF
CONTAINER
TOP HALF
CONTAINER
BOTTOM
HALF
PRESS TOGETHER
TO FORM SEAL
WHILE LIFTING
TOP HALF
LOCKING
TAB
ASSEMBLY CHECK: Squeeze sides of lower half of con- tainer and check that there is no gap between upper and lower halves. If a gap appears, unlock tabs to separate container halves and repeat instructions above.
|
|
| iner | is |
|
| onta | en |
|
| nsta | lled.Cce wher. |
| |
| epla ntain |
| ||
| erlyisntly. Rent co |
|
| |
| iner isbpargopfdrerqeupelacem |
|
| |
| conta heck ende |
|
|
|
| nlesstion. Ccomm |
|
|
|
| INGmowdeer tuierioonraly a re |
|
|
|
WAoRt oNpewraetaer aagnedd. Use |
|
|
| |
Do n ct to | dam |
|
|
|
subjeked or |
|
|
|
|
crac |
|
|
|
|
LANCED TABS
MOUNTING
BRACKET
FIG. 5
FIG. 4 | 8 |
