Husqvarna CT16 To Install the Throttle CON, Trol Assembly, To Install the Remote SHUT-OFF Switch

			ASSEMBLY
IMPORTANT: OVERTIGHTENING THE SCREWS		NO. 10 X 1-1/2 INCH	FIG. 4-ASSY
	ENOUGH TO CHANGE THE SHAPE
		HEX HEAD SCREW
	OF THE HANDLES CAN RESULT IN	HANDLE
		HANDLE	GRIP
	DAMAGE TO THE ENGINE CASTING.
		GRIP
● Hold the curved head carriage bolt against theoutside of			UPPER
			HANDLE
	the lower handle while tightening the tee knobs securely.
		TEE	HEX
			NUT
TO INSTALL THE THROTTLE CON-		KNOB
TROL ASSEMBLY
● Place a No. 10 x 1-1/2 inch hex head screw down		THROTTLE	LEFT LOWER
	through the hole in the upper handle right side and	CONTROL	HANDLE
	attach the throttle control to the underside of the	FORMED
	handle (See FIG. 4-ASSY).	WASHER
● Attach the throttle cable to the right lower handle by		CURVED HEAD
	threading a tie strap through the hole in the lower	CARRIAGE
	handle and around the throttle cable on the outside	BOLT
	of the handle (See FIG. 4-ASSY).	11/32 INCH
	Thread the pointed end of the strap through the	FLATWASHER
●		TIE STRAP	RIGHT LOWER
	other (square) end of the strap and pull tight around		HANDLE
	the throttle cable and lower handle.

NOTE: One side of the tie strap is rough, while the other side is smooth. The rough side must be on the inside of the loop formed when the ends of the tie strap are put together.

●Try to loosen the tie strap. If it will loosen, it is put together with the smooth side to the inside of the loop. Remove the tie strap and reverse the direc- tion.

●Cut off excess strap.

TO INSTALL THE REMOTE SHUT-OFF SWITCH

●Assemble shut off switch (See FIG. 5-ASSY).

●Attach assembled switch to left lower handle (switch on inside of handle) with a No. 10x1-1/16 inch hex head screw and a No. 10 keps nut. Tighten securely.

●Push switch wire onto prong on bottom side of switch (See FIG. 5-ASSY).

●Attach switch wire to left lower handle (See FIG. 6- ASSY) as close to the engine casting as possible with a

cable tie strap.

FIG. 5-ASSY

FIG. 6-ASSY

5