Manuals / Husqvarna / Lawn and Garden / Tiller

Husqvarna CT20 manual Assembly, nCHECKLIST

Models: CT20

1 30

Page 11

ASSEMBLY

nCHECKLIST

For the best performance and satisfaction from this quality product, please review the following checklist before you operate the cultivator:

nAll assembly instructions have been completed.

nCheck carton. Make sure no loose parts remain in the carton.

nAll fasteners have been properly tight- ened.

As you learn how to use the cultivator, pay extra attention to the following important items:

nnFuel tank is filled with a fresh, clean, oil and fuel mixture.

nnBecome familiar and understand the function of all controls. Before you start the engine, operate all controls.

MS−3615MA

Page 11

Image 11

Husqvarna CT20 manual Assembly, nCHECKLIST

Contents

PRODUCT INFORMATION Instruction Book - Model CT20SECTION 1 LIMITED WARRANTY WARRANTY STATEMENTHUSQVARNA 7349 Statesville Road Charlotte, NC SECTION 3 ITEMS NOT COVERED BY THIS WARRANTYSECTION 4 EXCEPTIONS AND LIMITATIONS SECTION 5 CUSTOMER RESPONSIBILITIESINTERNATIONAL SYMBOLS TABLE OF CONTENTSWARRANTY SAFETY RULESRESPONSIBILITY OF THE OWNER OWNER’S INFORMATIONSafe Operation Practices for Cultivator SAFETY RULESFuel Safety Operating SafetySafe Storage SAFETY RULESRepair / Adjustments Safety Safety Warning Symbols INTERNATIONAL SYMBOLSSAFETY RULES Control And Operating SymbolsHOW TO ASSEMBLE THE HANDLE ASSEMBLYASSEMBLY HOW TO REMOVE THE CULTIVATOR FROM THE CARTONCAUTION: Over tightening the lock ASSEMBLYoutside of the lower handle as you tighten the knobsnCHECKLIST ASSEMBLYChoke Control Lever − Use to assist OPERATIONKNOW YOUR CULTIVATOR EYE PROTECTIONHow To Operate The Cultivator HOW TO USE THE CULTIVATORHow To Stop The Cultivator How To Set The DepthBEFORE STARTING THE ENGINE How To Prepare The EngineHow To Mix The Fuel Mixture OPERATIONthese areas HOW TO START THE ENGINEOPERATION NOTE Do not choke a hot or warm engineSeed bed preparation 4 to 6 inches depth HINTS FOR DEPTH STAKE OR WHEEL ADJUSTMENTOPERATION CULTIVATING TIPSMAINTENANCE WARNING Allow the transmis MAINTENANCEHOW TO CLEAN THE TINES LUBRICATIONCYLINDER EXHAUST PORTS MAINTENANCEHOW TO CLEAN THE AIR FILTER SPARK PLUGTine Removal SERVICE AND ADJUSTMENTHOW TO REMOVE AND INSTALL THE TINES Tine InstallationCarburetor SERVICE AND ADJUSTMENTHOW TO ADJUST THE CARBURETOR Engine Shown With Fuel Tank RemovedEngine SERVICE AND ADJUSTMENTSTORAGE CultivatorCORRECTION TROUBLE SHOOTING CHARTTROUBLE CAUSEFACTORY NO. 11054x37NA MODEL CT20DESCRIPTION MODEL CT20FACTORY NO. 11054x37NA PART NO482483 MODEL CT20FACTORY NO. 11054x37NA 601 MODEL CT20FACTORY NO. 11054x37NA 650 660 662946 948 MODEL CT20FACTORY NO. 11054x37NA MS−3615MA MODEL CT20FACTORY NO. 11054x37NA DESCRIPTIONMS−3615MA