Husqvarna CTH151 owner manual TO ASSEMBLE BAGGER See Figs, Assembly, D

ASSEMBLY

•Start the engine.After engine has started, move throttle control to idle position.

•Release parking brake.

•Slowly move the motion control lever forward and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

•Turn ignition key to "OFF" position.

Continue with the instructions that follow.

TO INSTALL BAGGER COMPONENTS TO TRACTOR (See Figs. 4A-4D)

•Remove discharge chute from rear of tractor. Unhook the two (2) straps and pull chute out and away from tractor.

•Remove the two (2) 3/8 nuts and flat washers from the bolts at the tractor back plate.

DISCHARGE

CHUTE

3/8 NUT

FLATWASHER

0 2277

FIG. 4A

•Using the nuts and flat washers removed from tractor back plate, install the bagger support tube to the back plate as shown. Tighten securely.

SUPPORT

TUBE

FLAT

WASHER

3/8 NUT

BOLT 02330

FIG. 4B

•Install the two upper support brackets through the back plate and to the chassis, using the 10 x 19 mm (3/8"x3/4") carriage bolts and locknuts supplied.Tighten securely.

•Assemble both support brackets to the outside of the baggger support tube using two each 3/8 x 63,5mm hex bolts13/32" I.D. flat washers and 3/8 locknuts from parts bag. Tighten securely.

•Replace discharge chute into rear opening of tractor. Secure the chute with the two hook straps.

3/8 LOCK NUT

3/8 LOCK NUT

SUPPORT BRACKET

13/32 FLAT WASHER

3/8 HEX BOLT

3/8 CARRIAGE BOLT 02590

FIG. 4C

NOTE:The strap hook must go through the discharge chute only. Do not allow the hook to enter the slot in the tractor back plate.This will allow the discharge chute to float with the mower deck when moving on uneven terrain.

DISCHARGE

CHUTE

	HOOK
02306	BACKPLATE

SLOT

FIG. 4D

TO ASSEMBLE BAGGER (See Figs. 5 & 6)

NOTE: For ease of assembly, you may wish to obtain the assistance of another person when putting the bagger together.

•Holes in front bagger tube are at an angle. Place front bagger tube against lower bagger tube and check for proper hole alignment before assembling bolts.

•Assemble front and lower bagger tubes using four (4) 1/4 x 50,8mm carriage bolts and lock nuts supplied. Tighten securely.

FRONT BAGGER TUBE		LOWER
		BAGGER
		TUBE
1/4 X 2"
CARRIAGE	1/4 LOCK
BOLTS		2
	NUT	0259

FIG. 5

•Slide front and lower bagger tube assembly into the bagger assemby.

•Assemble front and upper bagger tubes using four (4) 1/4 x 50,8mm carraige bolts and lock nuts supplied. Tighten securely.

8