SERVICE AND ADJUSTMENTS

TO REMOVE WHEEL FOR REPAIRS (See Fig. 33)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent fl at tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

 

02614

WEAK OR DEAD

FULLY CHARGED

BATTERY

BATTERY

FIG. 34

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY

(REAR WHEEL ONLY)

FIG. 33

TO START ENGINE WITH A WEAK BATTERY (See Fig. 34)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE

CONNECTOR

02141

FIG. 35

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual.

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment,

26see engine manual.

Page 25 Page 27
Page 26
Image 26
Husqvarna CTH151 XP To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse, To Adjust Throttle Control Cable
Page 25 Page 27

CTH151 XP specifications

The Husqvarna CTH151 XP is a state-of-the-art compact tractor designed for both commercial and residential use. This versatile machine is engineered to provide outstanding performance, efficiency, and user comfort, making it an ideal solution for a variety of landscaping tasks.

One of the standout features of the CTH151 XP is its powerful engine. Equipped with a robust engine that delivers ample horsepower, this tractor can effortlessly handle heavy workloads. Its efficient fuel consumption ensures that operators can work for extended periods without frequent refueling, leading to increased productivity and cost savings.

The CTH151 XP boasts an innovative transmission system, featuring a hydrostatic drive that allows for smooth and precise control at various speeds. This feature is especially valuable for tasks that require nuanced maneuvering, such as mowing or trimming in tight spaces. The dual pedals enable easy speed and direction changes, enhancing the overall driving experience.

Another notable characteristic of the CTH151 XP is its ergonomic design. The comfortable seating arrangement and user-friendly controls are designed to reduce operator fatigue, allowing for long hours of efficient operation. The adjustable steering wheel and controllable armrests provide additional comfort, enabling users to find their ideal driving position.

Husqvarna has integrated advanced technology into the CTH151 XP, ensuring that it meets modern landscaping demands. The built-in cutting deck features an adjustable height, allowing for precise lawn maintenance. This feature is particularly beneficial for achieving a professional finish on varying terrain.

The CTH151 XP is designed with durability in mind. Its rugged construction and high-quality materials ensure that the tractor can withstand harsh operating conditions. Furthermore, the tractor’s maintenance-friendly design allows for easy access to key components, making routine maintenance tasks more straightforward.

The compact size of the CTH151 XP makes it maneuverable in confined spaces while still providing a powerful performance comparable to larger tractors. Lawn care professionals and homeowners alike will appreciate its versatility, as it can easily transition from mowing to snow clearing or hauling.

In summary, the Husqvarna CTH151 XP combines power, versatility, and comfort in a package that meets the demands of any landscaping task. With its advanced technology, ergonomic design, and durable construction, this compact tractor is a reliable choice for those seeking efficiency and effectiveness in their outdoor projects.
Top Page Image Contents