Husqvarna DTF6(BF) Seed Application, Bagger Attachment and Removal, Preparing the Lawn, operation

operation

Seed Application

Preparing the Lawn

•Cut the grass to approximately ½" (1-1.5 cm) lower than you normally would.

•Do not water before sowing.

•Remove the layer of old grass cuttings (thatch).

•Aerate the lawn with a core-type ground aerator.

•Fertilize the lawn.

Seed Application Chart

Located on the seeder, the chart values are approximate; quantities of seed depend on the speed at which the machine is run. Faster running speeds results in sparser sowing.

To set the seed application, loosen the wingnut and turn the seeder dial to the desired sowing setting. Retighten wingnut.

Pull back on the OPEN/CLOSE lever to apply seed.

Seed Application Recommendations

•For best results, sow in two directions with a 45° angle between.

•Water generously immediately afterward and continue watering moderately for 10–14 days to keep the soil moist.

•After germination, water sporadically to encourage root growth.

Bagger Attachment and Removal

To attach bagger, place foot on safety door rear bolt and push down until door is flat. Set the bagger onto the door and up against the chute.

1	2
	3
	8060-021

1.Selection dial

2.Wingnut

3.OPEN/CLOSE lever

Set application per chart and turn on seeder

2

1

8060-032

1.Safety door

2.Rear bolt

Attach bag to bagger frame

Secure bag clamp.

To remove door, unlatch bag clamp. Push down on rear bolt and slide bagger away from the chute. The safety door is spring loaded and will flip up to cover the rear opening until the bag is reinstalled.

8060-023

Secure bag latch

19