Husqvarna DXR-310 manual KEY to Symbols, Symbols on the machine

KEY TO SYMBOLS

Symbols on the machine

WARNING! The machine can be danger- ous if used incorrectly or carelessly, and can cause serious or fatal injury to the operator or others.

Please read the Operator’s Manual care- fully and make sure you understand the instructions before using the machine.

Noise emission to the environment ac- cording to the European Community’s Directive. The machine’s emission is speciÞed in chapter Technical data and on label.

Always wear:

• Tight-Þtting, heavy-duty and comfort- able clothing that permit full freedom of movement.

•Sturdy, non-slip boots or shoes.

•Protective gloves.

•Protective helmet.

•Hearing protection.

•Protective goggles or visor.

•A breathing mask, gas mask or fresh air helmet must be used when work- ing in environments where the air can be harmful to health.

WARNING! High-voltage current.

WARNING! Ensure that no material can fall down and cause damage when you are using the machine.

WARNING! Watch out for demolition mate- rial becoming loose when cutting. Use personal safety equipment and keep your distance.

WARNING! Always position yourself above the machine when driving on a slope. There is a risk of the machine tipping.

WARNING! Exercise particular caution when working close to edges. Ensure that the machine is stable and does not move closer to the edge while the work is in progress. Ensure that the underlying sur- face has satisfactory bearing capacity.

Inspections and/or maintenance must be carried out with the motor switched off and the power cord disconnected.

Always connect the machine through an earth-fault breaker with personal protection, i.e. an earth fault circuit breaker that trips at an earth fault of 30 mA.

Ensure that the power cable can- not be run over. Take particular care when moving or when the outriggers are being retracted or extended. Risk of electric shock.

The lifting equipment must be attached at all the machine’s lifting points.

Keep your distance! Nobody is permitted to be within the machine’s risk area when work is underway. The machine’s risk area can vary during the course of the work.

The machine can overturn during work. During operation the machine must be positioned as level as pos- sible and the outriggers must be fully extended.

This product is in accordance with ap- plicable EC directives.

English - 5