Husqvarna EZF 3417/ 965879301 manual Nose Roller, Maintenance

MAINTENANCE

3.Turn both outer blades to align with the deck in front-to-rear manner. Reposition rear mounting bolts up or down until rear of mower deck is positioned level to 1/8" higher in the rear than the side-to-side measurement.

4.Confirm measurements once again. Blade tips should be level in a side-to-side manner. In the rear, blade tips should be level to 1/8" higher than side-to-side measurement. In the front, blade tips should be level to 1/8" lower than side-to-side measurement.

NOTE: This will place the mower deck in

abase measurement position. Ad- ditional adjustment may be required to achieve desired cut for the type of grass or conditions being mowed.

Nose Roller

Nose rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Nose rollers keep the deck in the proper position to help prevent scalping in most terrain conditions.

•Adjust the deck to the desired cutting height (see “TO ADJUST DECK CUTTING HEIGHT” in the operation section of this manual).

•Using a 9/16" wrench, remove the nut and shoulder bolt from the nose roller.

•Lower the roller to the ground, and raise it up to the next highest hole.

•Replace and tighten the nut and shoulder bolt.

Be sure to readjust the nose roller if the cutting height is changed.

2

1

1.Bolt

2.Nut Nose roller

English-42