___________________________________________________________________________________________________________________________________________________________________________________
FAULT | CAUSE | REMEDY |
Blade turns wrong way. | Phases from power cable are inverted. | Change polarity using phase inverter. |
|
|
|
Drive belt is slipping. | Belt is too slack. | Adjust belt tension. |
| Drive belt is worn. | Replace the drive belt. |
| Drive belt is oily. | Clean the drive belt. |
|
|
|
Motor cuts out. | Cutting depth too large. | Reduce cutting depth. |
| Cutting speed too high. | Advance more slowly. |
| Diamond segments are worn. | Replace diamond blade. |
| Electrical fault. | Contact a qualified electrician. |
|
|
|
No cooling water. | Nozzles are blocked. | Clean nozzles. |
| Water pressure low. |
|
|
|
|
Blade gets jammed. | Blade is worn. | Replace blade. |
| Cut closing up. | Cut smaller sections, or |
|
| support from below using props or a jack. |
|
|
|
Motor does not start. | Electrical fault. | Contact your electrician. |
| Emergency stop activated. | Determine cause. When fault is |
|
| fixed, pull up emergency stop. |
|
|
|
NOTE! Do not start the machine before rectifying the cause of the fault.
9. Technical specifications
The table below gives the technical specifications for the FS800 E/EM floor saw. It is extremely important that you check these before:
-Choosing a floor saw.
-Choosing and fitting a diamond blade.
-Connecting to the mains supply.
-Choosing a power cable.
-Choosing the cutting depth.
-Transporting the machine.
If you are unsure about the meaning of the technical specifica- tions or ordering spare parts, please contact your supplier
FS800 E/EM ART. NOS. 50020 AND 50030
Motor rating | kw | 7.5 |
|
|
|
Voltage and type of supply | V/phase/Hz | 400/3/50 or |
|
| 220/3/50 |
|
|
|
Power cable | REVE | 5x2.5 |
|
|
|
Polarity | Europa plug | 16 Amp. |
|
|
|
Phase inverter |
| in socket |
|
|
|
Drive shaft speed | rpm | 1150 |
|
|
|
Max. peripheral speed. | m/s | 63 |
|
|
|
Max. diamond blade diameter | mm | 800 |
|
|
|
Parking brake |
| yes |
|
|
|
Base plate |
| optional |
|
| accessory |
|
|
|
Chain drive |
| optional |
|
| accessory |
|
|
|
Max. Cutting depth | mm | 320 |
|
|
|
Length approx. | mm | 1500 |
|
|
|
Width approx. | mm | 780 |
|
|
|
Height approx. | mm | 1120 |
|
|
|
Weight (excl. blade) approx. | kg | 220 |
|
|
|
Noise | noise power | <101.7 |
| Lw rel. pw |
|
| according to ISO |
|
| 744 dB(A) |
|
|
|
|
Noise | noise pressure | <84.8 |
| Lp rel. 0µPa at |
|
| ear during |
|
| operation B(A) |
|
|
|
|
Vibration | according to. | 0.8 m/s2 (H/A) |
| ISO 7505 |
|
|
|
|
10
