Husqvarna FS 800 EM manual Safety precautions

___________________________________________________________________________________________________________________________________________________________________________________

2. Safety precautions

You must follow the safety precautions before starting the machine. If the user does not follow these precautions then neither Husqvarna Construction Products Sweden AB nor its re- presentative can accept any liability, whether direct or indirect.

The machine must not be used by any authorised person unless supervised by an authorised and experienced operator.

WARNING! Make sure you have read and understood the instructions in this manual before connecting the machine to the electrical supply.

•Check that the electrical connections are secure and that the power cable and plug comply with the specifications. See section 9 Technical specifications.

•Make sure that no-one comes closer than 4 metres to the front or side of the floor saw during operation.

•Check that the blade guard and blade flange guard are fitted correctly.

•The emergency stop must not be deactivated during start- up or operation.

•Before you start cutting, plan your work and clearly mark out the area you intend to cut so that you can carry out the work without risk of injury or damage to the machine. See figure 3,1.

•Check the building drawings to make sure there is no concealed wiring or plumbing in the area where you are cutting.

•Before you start cutting, make sure that any wiring in your working area is not carrying current.

•Before you start cutting, make sure that any plumbing in your working area has been shut off or disconnected.

•You must use the specified protective equipment and should wear protective clothing. See following page. Do not wear loose-fitting clothes that could catch on the machine or its moving parts.

•Anyone who has to remain nearby during cutting must wear hearing protection.

•Do not tilt, twist or carry the floor saw when the blade is turning.

2.1.Warning signs and their locations.

The machine rating plate is located on the right side of the frame, as shown below.

Machine model: FS800 E/EM

Motor rating: 7,5 kW

Max. drive shaft rpm: 1150 rpm

Max. blade diameter: 800 mm

Max. peripheral blade speed: 63 m/s

Weight: (excl. blade) 220 kg

Year of manufacture:

Manufacturer: Husqvarna Construction Products Sweden AB

Warning signs and their locations

The following decals on top of the frame explain that:

you should read and follow the instruction manual before operating the floor sawyou should wear safety equipment.

The emergency stop is labelled The control panel is labelled

NÖDSTOPP

A decal on top of the blade guard

shows the direction of rotation of

the blade.

Protective equipment

The following protective equipment must be used when working with the floor saw.

Helmet, hearing protection	You must wear safety shoes
and eye protection

3. Preparations before starting

NOTE! Follow the safety precautions.

Do not fit a blade without first checking the direction of rota- tion of the drive shaft.

Plan your work and mark out the area to be cut.

•Check that the power cable and polarity match the speci- fications. See section 9 Technical specifications.

5