OPERATION
The operation of any tiller can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields before starting your til- ler and while tilling. We recommend a wide vision safety mask over spectacles or standard safety glasses.
00155
HOW TO USE YOUR TILLER
Know how to operate all controls before adding fuel and oil or attempting to start engine.
STOPPING (See Fig. 5)
TINES
•Release forward tine control to stop forward move- ment.
•Release reverse tine control to stop reverse move- ment.
ENGINE
•Move throttle control to “STOP” position.
•Never use choke to stop engine.
REVERSE TINE | REVERSE TINE | FORWARD | |||
TINE CONTROL | |||||
CONTROL IN | CONTROL | ||||
IN “OFF” (UP) | |||||
“OFF” (UP) | IN “ON” (DOWN) | ||||
POSITION | |||||
POSITION | POSITION | ||||
| |||||
|
|
| FORWARD TINE CONTROL | ||
|
|
| IN “ON” (DOWN) POSITION | ||
handles | _ | 94 |
|
| |
|
|
| |||
|
|
|
| ||
|
|
|
| THROTTLE | |
|
|
|
| CONTROL | |
CHOKE |
|
|
|
| |
CONTROL | engi |
| |||
|
|
|
| ||
|
|
| ne |
| |
|
|
| _a |
| |
|
|
| rt_ |
| |
|
|
| 71 |
| |
Fig. 5
TINE OPERATION (See Fig. 5)
FORWARD
•With reverse tine control in the “OFF” (up) position, Squeeze forward tine control to handle.
REVERSE
•With forward tine control in the “OFF” (up) position, Squeeze reverse tine control to handle.
TILLING
The speed and depth of tilling is regulated by the position of the depth stake and wheel height.
The depth stake should always be below the wheels for digging. It serves as a brake to slow the tiller’s forward motion to enable the tines to penetrate the ground. Also, the more the depth stake is lowered into the ground the deeper the tines will dig.
DEPTH STAKE (See Fig. 6)
Adjust depth stake by removing the hairpin clip and clevis pin. Change depth stake to desired position. Replace the clevis pin and hairpin clip.
•For normal tilling, set depth stake at the second or third hole from the top.
WHEELS (See Fig. 6)
Adjust wheels by removing the hairpin clip and clevis pin. Change wheel position. Replace the hairpin clip and clevis pin.
•For normal tilling, set wheels at the second or third hole from the top.
dept |
|
h |
|
_ | |
| stake |
| _ |
| 4 |
| HAIRPIN CLIP |
| AND CLEVIS PIN |
| DEPTH |
| STAKE |
| STAKE |
| SPRING |
| WHEEL |
Fig. 6
7
