Husqvarna GTH2648 Unassembled Parts, Assembly, To Remove Tractor From Carton, Slope Sheet Key

Models: GTH2648

1 44
Download 44 pages 47.97 Kb
Page 5
Image 5
UNASSEMBLED PARTS

UNASSEMBLED PARTS

Slope Sheet

Key

(1) Oil Drain Tube

(2) Keys

ASSEMBLY

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping puposes.

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.

Remove mower and packing materials.

Remove protective materials from tractor hood and grille.

IMPORTANT: Check for and remove any staples in skid that may puncture tires where tractor is to roll off skid.

CHECK BATTERY (See Fig. 1)

Lift hood to raised position.

NOTE: If this battery is put into service after month and year indicated on label (L) (label is located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in Maintenance section of this manual for charging instructions).

ADJUST SEAT (See Fig. 2)

Sit in seat.

Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.

Release lever to lock seat in position.

A

FIG. 2

L

02931

FIG. 1

5

Page 5
Image 5
Husqvarna GTH2648 owner manual Unassembled Parts, Assembly, To Remove Tractor From Carton, Slope Sheet Key, Unpack Carton