Vehicle Controller – Electric Vehicles

VEHICLE CONTROLLER – ELECTRIC VEHICLES

The electric vehicle is equipped with a solid state speed controller. In order to properly service and maintain the solid state controller vehicle, it is necessary to understand the electrical circuitry and the functions of all components in both systems. Therefore, if any repair or servicing needs to be performed, we recommend that it be performed by an authorized Husqvarna distributor/dealer using Husqvarna parts.

BATTERIES – ELECTRIC VEHICLES

See General Warnings on page 9.

ýDAN G E R

Battery – Explosive gases! Do not smoke. Keep sparks and flames away from the vehicle and service area. Ventilate when charging or operating vehicle in an enclosed area. Wear a full face shield and rubber gloves when working on or near batteries.

Charge batteries in a well-ventilated area only. Batteries emit hydrogen while being charged. Hydrogen is an explosive gas and must never exceed a level of 2% of the air.

Battery – Poison! Contains acid! Causes severe burns. Avoid contact with skin, eyes, or clothing. Antidotes:

-External: Flush with water. Call a physician immediately.

-Internal: Drink large quantities of milk or water followed with milk of magnesia or vegetable oil. Call a physician immediately.

-Eyes: Flush with water for 15 minutes. Call a physician immediately.

ýWARNING

Wear safety glasses or approved eye protection when servicing the vehicle or battery charger. Wear a full face shield and rubber gloves when working on or near batteries.

Use insulated tools when working near batteries or electrical connections. Use extreme caution to avoid shorting of components or wiring.

CAUT ION

• On all electric vehicles, turn off all accessories before charging batteries.

NOTE: Recycle or dispose of discarded batteries in accordance with local, state, and federal regulations.

Husqvarna electric vehicles use 12-volt, deep-cycle batteries. Automotive batteries should never be used.

New batteries will not deliver their full capabilities until they have been discharged and recharged 20 to 50 times. To obtain the maximum service life from new batteries, restrict vehicles with new batteries to one hour of operation between charges for the first two months vehicle is in service. Batteries should be fully charged before first use of new vehicle, before first use of a vehicle after storage, and before use each day.

BATTERY CARE

To keep batteries in good working condition, follow this maintenance program on a regular basis:

Page 34 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual

Page 36
Image 36
Husqvarna HUV4210-GXP, HUV4210-E manual Vehicle Controller Electric Vehicles, Batteries Electric Vehicles, Battery Care