Husqvarna HUV4210-GXP, HUV4210-EXP manual Fueling Instructions Gasoline Vehicles

Fueling Instructions – Gasoline Vehicles

-20°C -10°C		0°C	10°C 20°		30°C 40°C
					SAE 40
			SAE 30
	SAE 10W-30/SAE 10W-40
SAE 5W-20
-4°F	14°F	32°F	50° F	68°F	86°F	104°F

Figure 31 Oil Viscosity Chart

FUELING INSTRUCTIONS – GASOLINE VEHICLES

See General Warnings on page 9.

ýDAN G E R

•Turn the key switch to the OFF position before fueling.

•Do not pour gasoline into the fuel tank when the engine is hot or while it is running.

•To avoid electric arc caused by static electricity, the fuel storage/pumping device must be grounded. If the pump is not grounded, the vehicle must be grounded to the pump before and during the fueling operation.

•If the vehicle has an all-weather enclosure installed, be sure the fuel tank is properly vented as shown (Figure 32).

•To avoid the possibility of fire, clean up any spilled gasoline before operating the vehicle.

ýCAUT ION

•To allow for expansion, do not fill higher than one inch from the top of the fuel tank. Avoid fuel spillage.

NOTE: Whenever possible, avoid using oxygenated fuels and fuels that are blended with alcohol. Vehicles to be stored for extended periods should be prepared for storage as instructed. See Preparing the

Gasoline Vehicle for Extended Storage on page 26.

1.Turn the key switch to the OFF position.

2.Lift and remove seat bottom.

3.The fuel tank is located on passenger side of vehicle. Remove fuel cap and fill the fuel tank with fresh unleaded gasoline only. See preceding CAUTION.

4.Replace fuel cap on tank. Ensure cap is tightened securely.

5.Replace seat bottom.

Page 44 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual