Husqvarna I0807213 manual Lifting Link, 5/8 NYLOCK NUT, 5/8 JAM NUT, 5/8x HEX BOLT

5.Place the L.H. Pivot Bracket onto the end of the Lift Lever Assembly (the R.H. Pivot Bracket comes already installed on the assembly). See fi gure 3.

6.Attach the R.H. and L.H. Pivot Brackets to the Sleeve Hitch Frame Assembly using four 3/8" x 1" carriage bolts and 3/8" nylock nuts. See fi gure 3.

L.H. PIVOT BRACKET

R.H. PIVOT BRACKET

LIFT LEVER

ASSEMBLY

3/8-16 x 1"

CARRIAGE

BOLT

3/8" NYLOCK NUT

SLEEVE HITCH FRAME

FIGURE 3

8.Assemble the two 5/8" jam nuts halfway onto the two 5/8" x 2" hex bolts. Screw the bolts into the nuts that are welded to the Sleeve Hitch Lift Assembly. Tighten the jam nuts against the welded nuts. See fi gure 5.

9.Assemble the lifting link to the Sleeve Hitch Lift Assembly using a 5/8" x 1-3/4" hex bolt and a 5/8" nylock nut.Use the bottom hole in the lifting link (gives the lowest implement depth setting). Tighten the nut only until snug. Do not squeeze the welded arms together. See fi gure 5.

LIFTING LINK
5/8" NYLOCK NUT	5/8"x 1-3/4"
5/8" JAM NUT	HEX BOLT

5/8"x 2"

HEX BOLT

7.Hook the Sleeve Hitch Frame Assembly onto the weld pins in the mounting brackets. Attach the bottom of the Assembly to the tractor hitch using a 5/8" x 1-3/4" hex bolt and a 5/8" nylock nut. See fi gure 4.

NOTE: If your tractor hitch has ridges that prevent the sleeve hitch assembly from resting fl at, place the spacer plate underneath the sleeve hitch assembly.

SLEEVE HITCH	LIFT LEVER
FRAME ASSEMBLY	ASSEMBLY

HEX BOLT 5/8" x 1-3/4"

SPACER PLATE

(SEE NOTE)

WELD
PIN	5/8" NYLOCK NUT

FIGURE 4

FIGURE 5

10.Attach the Sleeve Hitch Lift Assembly to the Sleeve Hitch Frame Assembly using three 5/8" x 1-3/4" clevis pins and 3/32" hair cotter pins as shown in fi gure 6.

11.Install the hitch pin in the sleeve hitch and secure it with the 5/32" hair cotter pin. See fi gure 6.

HITCH PIN

5/32" HAIR COTTER PIN

(3) 3/32" HAIR

COTTER PINS

(3) CLEVIS PINS

FIGURE 6

4