CARTON CONTENTS
1 | 2 | 4 | 5 |
|
| ||
|
|
| |
|
| 3 |
|
7
6
8
1.Sleeve Hitch Frame Assembly
2.Mounting Bracket (R.H.)
3.Mounting Bracket (L.H.)
4.Lifting Link Plate
5.Hitch Pin
6.Lift Lever Assembly (with R.H. Pivot Bracket)
7.L.H. Pivot Bracket
8.Sleeve Hitch Lift Assembly
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(1)1/2" Wrench or Adjustable Wrench
(2)9/16" Wrenches or Adjustable Wrenches
(1)15/16" Wrenches or Adjustable Wrenches
1.Assemble a 5/16" x 1" hex bolt, a spacer and a 5/16" nylock nut to the three position slot in the R.H. pivot bracket on the left lever assembly. Use the position closest to the bend in the bracket (lowest implement depth setting). See fi gure 1.
IF YOUR TRACTOR LOOKS LIKE FIGURE 2A
2.Install two 3/8" x
3/8" x
HEX BOLT
RIGHT MOUNTING BRACKET
LEFT MOUNTING BRACKET
3/8" LOCK WASHER
3/8" HEX NUT
FIGURE 2A
IF YOUR TRACTOR LOOKS LIKE FIGURE 2B
3.Remove the nuts from the two bolts in each side of the tractor, leaving the bolts in place. See fi gure 2B.
4.Attach the left (LH) and right (RH) Mounting Brackets to the bolts using the original nuts and two 3/8" fl at washers. The brackets should angle outward with the weld pins at the top of the brackets facing inward. See fi gure 2B.
NOTE: If no bolt and nut are present in a hole, use a 3/8" x
RIGHT MOUNTING
BRACKET
SPACER
PIVOT
5/16" X 1" BRACKET HEX BOLT
FIGURE 1
5/16" NYLOCK
NUT
REMOVE NUTS
FROM BOLTS
3/8" FLAT WASHER
(TOP HOLE ONLY)
LEFT MOUNTING
BRACKET
3/8" LOCK WASHER
(If new bolt and nut are needed)
ORIGINAL NUT
FIGURE 2B
3