MAINTENANCE

Maintenance

!

WARNING! Inspection and/or maintenance

should be carried out with the hydraulic

hoses disconnected.

Dismantling the complete guide roller

Remove the support roller cover.

Lift off the blade.

Unscrew the knob. First turn the knob a few turns until you feel a resistance. The guide roller then follows the knob out and stops when it feels a resistance.

The guide roller is pressed into the knob. In order to loosen the guide roller, you need to continue turning the knob until it loosens completely.

The guide roller can now be pulled out of the chassis

Assembling the complete guide roller

Screw the knob until it bottoms, and then loosen the knob 2 turns.

Insert the guide roller in the chassis

Now press the guide roller into the knob.

Lubricate the guide roller’s sleeve using grease. Fit the grease gun on the grease nipples (A) and pump in grease until clean grease emerges from the overflow hole (B).

A

B

 

Fit the blade. See the heading Fitting the blade.

Important notes:

The support rollers do not drive the blade.

Incorrect adjustment can result in damage to the blade.

If the blade rotates slowly or stops, stop cutting immediately and trouble shoot.

English – 15

Page 15
Image 15
Husqvarna K 3600 MKII manual Maintenance, Dismantling the complete guide roller, Assembling the complete guide roller