MAINTENANCE
Starter |
|
! | WARNING! When the recoil spring is wound |
up in the starter housing it is under tension | |
and can, if handled carelessly, pop out and | |
| cause personal injury. |
Always be careful when changing the recoil spring or the starter cord. Always wear protective goggles.
Changing a broken or worn starter cord
•Loosen the screws that hold the starter against the crankcase and remove the starter.
•Pull the cord out about 30 cm and lift it into the
•Remove any remnants of the old starter cord and check that the return spring works. Insert the new starter cord through the hole in the starter housing and in the cord pulley.
•Secure the starter cord around the cord pulley as illustrated. Tighten the fastening well and ensure that the free end is as short as possible. Secure the end of the starter cord in the starter handle.
Tensioning the recoil spring
•Guide the cord through the
•Now pull the starter handle and in doing so tension the spring. Repeat the procedure once more, but this time with four turns.
•Note that the starter handle is drawn to its correct home position after tensioning the spring.
•Check that the spring is not drawn to its end position by pulling out the starter line fully. Slow the starter pulley with your thumb and check that you can turn the pulley at least a further half turn.
Changing a broken recoil spring
•Undo the bolt in the centre of the pulley and remove the pulley.
•Bear in mind that the return spring lies tensioned in the starter housing.
•Loosen the bolts holding the spring cassette.
•Remove the recoil spring by turning the starter over and loosen the hooks, with the help of a screwdriver. The hooks hold the return spring assembly on the starter.
•Lubricate the recoil spring with light oil. Fit the pulley and tension the recoil spring.
English – 21
