Husqvarna LT130 owner manual Connect Battery See Figs, Install Seat See Fig

ASSEMBLY

CONNECT BATTERY (See Figs. 2 and 3)

CAUTION: Do not short battery termi- nals. Before connecting battery, re- move metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Remove cardboard packing from seat pan and lift seat pan to raised position.

•Open battery box door.

•Remove terminal protective caps and discard.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps.

•First connect RED battery cable to positive (+) terminal with hex bolt, flat washer, lock washer and hex nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) termi- nal with remaining hex bolt, flat washer, lock washer and hex nut. Tighten securely.

•Close battery box door.

Open battery box door for:

•Inspection for secure connections (to tighten hard- ware).

•Inspection for corrosion.

•Testing battery.

•Jumping (if required).

•Periodic charging .

	DISCARD
POSITIVE	TERMINAL
	PROTECTIVE
(RED) CABLE	CAPS
	HEX	LOCK
		WASHER
	NUT
		FLAT
		WASHER
		HEX
		BOLT
	NEGATIVE
	(BLACK) CABLE

FIG. 2

SEAT

PAN

BATTERY

BOX DOOR

FIG. 3

INSTALL SEAT (See Fig. 4)

Adjust seat before tightening adjustment knob.

•Remove cardboard packing on seat pan.

•Place seat on seat pan and assemble shoulder bolt.

•Assemble adjustment knob and flat washer loosely. Do not tighten.

•Tighten shoulder bolt securely.

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

SEAT

SEAT PAN

SHOULDER

BOLT

ADJUSTMENT	LARGE FLAT WASHER
BOLT
	FIG. 4

7