SERVICE AND ADJUSTMENTS
TO REPLACE FUSE
Replace with 30 amp
TO REPLACE HEADLIGHT BULB
•Raise hood.
•Pull bulb holder out of the hole in the backside of the grill.
•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running or prevent it from starting.
•Check wiring. See the electrical wiring diagram in the Repair Parts section of this manual.
TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 32)
•Lift hood. Disconnect headlight wiring connection.
•Remove wingnut at rear of each side panel.
•Remove retainer springs from hood pivot brackets.
•Pivot hood and side panel forward and lift off tractor.
•To replace, reverse above procedure.
WINGNUT
HEADLIGHT WIRING CONNECTION
FIG. 32
ENGINE
TO ADJUST THROTTLE CONTROL CABLE (See Fig. 33)
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:
•With engine not running, move throttle control lever
from slow (
) to choke (
) position. Slowly move lever from choke (
) to fast (
) position.
•Check to see if hole in throttle lever and hole in speed control bracket are aligned.
•If holes are not aligned, loosen cable clamp screw and align the holes by inserting a pencil or a 1/4" drill bit through both holes.
•Pull throttle cable up to remove slack and tighten cable clamp screw. Remove alignment pencil or drill bit.
CABLE
CLAMP
SCREW
SPEED CONTROL
BRACKET
THROTTLE
LEVER
FIG. 33
24
