Husqvarna LTH1842 INSTALL SEAT See Figs. 2a and 2b, ATTACH HOOD SCOOP See b, CHECK BATTERY See a

ASSEMBLY

INSTALL SEAT (See Figs. 2a and 2b)

•Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard.

•Connect switch to seat.

•Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.

SEAT PAN

LABEL

BATTERY

BOX DOOR

SEAT

SWITCH

PAD

TERMINAL

02021

FIG. 3a

TERMINAL

SLOT

SEAT

PAN

TAPE

WIRING HARNESS

FIG. 2a

•Push down on seat to engage pads in slots and pull seat towards rear of tractor.

•Raise seat and tighten bolt securely.

•Remove tape and discard.

•Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.

ATTACH HOOD SCOOP (See Fig. 3b)

To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

SLOT		TAPE
PAD
FLAT
WASHER
SEAT PAN
BOLT	TAB	ADJUSTMENT
		HANDLE

FIG. 2b

CHECK BATTERY (See Fig. 3a)

•Lift seat pan to raised position and open battery box door.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps.

Fig. 3b

7