ASSEMBLY
7CHUTE SUPPORT
1.Position upper chute support against bagger inlet, flush at outer edges. See Illustration.
2.Using support as a template, drill two 3/8 holes into bagger hood.
Upper Chute Support
3.Secure upper chute support to hood with hex bolts, washers and nyloc nuts.
8COVER ASSEMBLY
NOTE: For ease of assembly, you may wish assistance from another person for mounting the cover assembly to mower.
1.Position cover assembly on ground behind mower.
2.Lift and rotate cover to align the cover brackets with support assembly tubes.
3.Slide the cover down over the support tubes until secure.
Cover Assembly
9MIDDLE CHUTE
Flex Trim | 1. | Place middle chute over the top end of the blower |
| ||
|
| assembly, lining up the blower latch and the |
|
| acorn nut on the middle chute. |
| 2. | Stretch bungee latch up onto acorn nut to secure. |
Middle Chute
Chute Latch
8
