Husqvarna QN 4021, QN 4039 manual Installation, Accessories, Built-in model, Electical connections

QN 4021 / QN 4039 t

Installation

QN 4021 / QN 4039 t

Description of the microwave oven

•When you unpack the oven, check that the product is free from damage. Damage or any missing parts must be reported immediately to the retailer. The oven, parts of the oven or the accessories may be wrapped by a pro- tection foil. If so, you must remove this foil before using the oven. Do not leave packing material so that small children can play with it. This can be hazardous.

•Do not use your appliance immediately (wait approx. 1-2 hours) after transfer from a cold place to a warm place as condensation may cause a malfunction.

•This oven can be used as a free stan- ding oven or built-in using the kit avail- able with the oven. To install the oven in a kitchen cabinet follow the instructions supplied with the building-in kit. The oven should be in-stalled on a flat, level surface at least 85 cm above floor level. The surface must be strong enough to safely bear the weight of the oven, and the contents. To avoid the possibility of causing vibration or noise, the oven must be in a stable position.

•Be sure to install the oven away from heat and water sources.

•Do not block air vents on the top and

the sides of the cabinet nor place any articles on the top of the oven. A gap all around the oven is necessary : 20 cm above the oven and any objects, 5 cm

on the sides
and 10	cm	20 cm
behind	the
oven. If	air
vents	are
b l o c k e d		5 cm
		5 cm
during ope-

ration, the oven may overheat, and this may lead to malfunctioning.

8

•This oven does conform to EEC require- ments* of radio interference suppression, but some interference may occur if it is placed too close to a radio or TV, so keep them as far apart as possible.

Built-in model

•To install the appliance in a kitchen cabinet, use the appropriate mounting frame, kit number EBR/BF 517 or 617 for model QN 4021 or kit number EBR/BF 624 for model QN 4039. When building into a high cabinet, you may use the liftdoor. Note the relevant infor- mation for installation and connection given in the operating instructions. Attention ! Never operate the micro- wave oven with the lift door closed. Such operation would damage your appliance and invalidate the guarantee.

Electical connections

•The oven is delivered with the power cord and a plug for 230-240 V, 50Hz, earthed socket outlet.

•Earth protection minimizes the risks should a short-circuit occur. Check to ensure the voltage of the oven matches the supply. N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.

This appliance must not be used on a non-earth protected power supply. Contact an electrician if you are uncertain regarding electrical connection of the oven or provision of earth protection of the supply.

•Microwave power output :

QN 4021 - 750W / QN 4039 - 900W

•This appliance complies with E.E.C. directive No. 87/308 of 2.6.87 relative to radio interference suppression.

1	Cooking compartment	5	Safety interlock system
2	Viewing window	6	Control panel
3	Oven door	7	Door open button
4	Door catch	8	Drive shaft for turntable

Accessories

Turntable and turntable support

The turntable and turntable support should be installed as shown in the dia- gram. Take care to ensure the turntable support is properly in place.

The turntable may turn clockwise or coun- terclockwise during operation. Do not rotate the turntable manually, as you could damage the drive system.

9