Husqvarna RZ4623/967009801 Weak Battery, Jumper Cables Use, To remove cables, reverse order

OPERATION

Weak Battery

WARNING!

Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

IMPORTANT INFORMATION

Your mower is equipped with a 12-volt negative grounded system. The other vehicle must also be a 12-volt negative grounded system. Do not use your mower to start other vehicles.

If the battery is too weak to start the engine, it should be recharged. (See Battery in the Maintenance section.)

Jumper Cables Use
1. Connect each end of the RED cable to the
POSITIVE (+) terminal on each battery, taking	8011-642
care not to short against chassis.	Jumper cable connection

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery.

3.Connect the other end of the BLACK cable to a good CHASSIS GROUND on the mower with the discharged battery, away from the fuel tank and battery.

To remove cables, reverse order

4.Remove BLACK cable first from chassis and then from the fully charged battery.

5.Remove RED cable last from both batteries.

29