ASSEMBLY
Fitting the loop handle
(325Cx)
•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
•Fit the screw, securing plate and wing nut as shown in the diagram.
•Tighten the wing nut.
Fitting the loop handle
(323L, 323LD, 325Lx, 325LDx)
•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.
•Slide the spacer into the slot in the loop handle.
•323L/323LD: Fit the nut, washer and screw.
325Lx/325LDx: Fit the nut, knob and screw. Do not overtighten.
•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.
Assembling and dismantling the two-piece shaft
(323LD, 325LDx)
Assembly:
•Loosen the coupling by turning the knob.
•Align the tab of the attachment (A) with the arrow on the coupling (B).
B
A
•Push the attachment into the coupling until the attachment snaps into place.
•Before using the unit, tighten the knob securely.
Dismantling:
•Loosen the coupling by turning the knob (at least 3 times).
•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.
C
10 – English
