ASSEMBLY
Assembling the cutting equipment
WARNING! When fitting the cutting
!attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.
Fitting a trimmer guard and Superauto II 1” trimmer head
(323L, 323LD, 325Lx, 325LDx)
|
| K |
K | G |
|
F | B | |
| I | |
J | I | C |
|
| |
|
| A |
•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the guard onto the fitting on the shaft and secure it with the bolt (L).
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•To fit the trimmer head, first separate the two halves (see diagram). Proceed as follows:
•Insert a finger into the centre hole of the cover (I) while grasping the cover with your other fingers. Using the index finger and thumb of your other hand, release the two catches (J) that engage in the
(K). Pull apart the trimmer head, grasping the cover firmly.
•Place the cover (I) and the support flange (F) on the output shaft.
•Fit the nut (G). The nut must be tightened to a torque of
•Fit the bottom half of the trimmer head (K) to the cover (I) by pressing them together, with the
•To dismantle, follow the instructions in the reverse order.
Fitting other guards and cutting attachments
(323L, 323LD, 325Lx, 325LDx)
•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L).
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Screw on the trimmer head/plastic blades (H) in the opposite direction to the direction of rotation.
H
H
•To dismantle, follow the instructions in the reverse order.
English – 11
