ASSEMBLY
TO INSTALL THE SHIFTER ROD
●Attach shift rod set aside earlier to the shifter lever with one (1) flatwasher and (1) cotter pin (See III.6).
●Place shift lever into sixth gear position. Rotate speed rod on rear of motor frame counterclockwise down until it stops.
●Align trunion nut on end of shift rod with the hole in the speed rod. If trunion nut does not align with hole in speed rod, twist trunion nut up or down on shift rod until it does line up.
●Put end of trunion nut through hole in speed rod and attach washer and cotter pin (See III.7).
●Move the shifter lever through all the speeds to ensure proper placement of the shifter lever.
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger clutch lever and traction clutch lever may need to be adjusted before you use your snow thrower.
Refer to "To Adjust the Clutch Control Cables" in the "Service and Adjustment" section on checking or ad- justing the control cables.
TO INSTALL CHUTE ASSEMBLY TO CHUTE FLANGE (III.8)
●Remove three carriage bolts, flatwashers, lockwashers and nuts from snow chute flange.
●Position snow chute on snow chute flange and align the three holes in the snow chute with tabs on snow chute flange.
●Replace the carriage bolts, from inside of chute as shown in III. 8, install flatwashers, lockwashers and nuts.
●Tighten nuts securely.
●Hook remote chute return spring supplied in parts bag through both spring bracket as on deflector and chute extension.
TO INSTALL REMOTE CHUTE DEFLECTOR LEVER KNOB
●Thread the knob onto the threaded end of the lever until it is snug against the hex nut and the lip is pointed toward the engine. Tighten the hex nut against the bottom of the lever knob (See III.
DRIFT CUTTER ASSEMBLY (IF EQUIPPED)
●Remove the fasteners securing the drift cutters and then rotate drift cutters 180° (See III.
●Reinstall fasteners and secure.
18
