Husqvarna ST 151 warranty Maintenance, Adjusting the Control Cable, Checking the Control Cable

MAINTENANCE

Maintenance

NOTE: Determine the left and right sides of the machine from the normal operating position.

Check for Loose Fasteners

Clean / Inspect Snow Thrower

Clean / Replace V-Belts

Check / Replace Auger Blades and Scraper Bar

Check Fuel Lines and Electrical Wires

Check Engine Oil Level

Change Engine Oil

Inspect Muffler

Check / Replace Spark Plug

Empty Fuel Tank

Adjusting the Control Cable

Checking the Control Cable

1.Release the control bar to remove the slack in the control cable (Figure 21).

NOTE: If the control cable is adjusted to position 2, ensure that the auger stops properly when the control bar is released

Adjusting the Control Cable

1.With the control bar disengaged, unhook and move the control cable to the highest position. (Figure 22).

1

12

Position 2

3

Figure 21

1. Control bar

Position 1: Default position

(Lower Hole as shown in illustration)

IMPORTANT: The control cable must contain some slack when you disengage the control bar for the auger blades to stop properly.

NOTE: You may need to adjust the control cable from position 1 (default) to position 2 if you notice belt slip when the control bar is engaged.

Figure 22

1.Control bar

2.Adjuster link

3.Cable positions

12