Husqvarna CD61L, TRD61L, TRD48i To adjust anti-scalprollers, Cleaning and Washing, Maintenance

MAINTENANCE

To adjust anti-scalp rollers

Anti-scalp rollers are properly adjusted when they are just slightly off of the ground when the deck is at the desired cutting height in the operating position. Anti- scalp rollers then keep the deck in the proper position to help prevent scalping in most terrain conditions.

Tunnel Deck -

The anti-scalp rollers can be set in three positions:

•Upper position 1½" to 3" / 38 to 76 mm grass.

•Middle position 3" to 4½" / 76 to 114 mm grass.

•Lower position 4½" to 6" /114 to 152 mm grass.

Combi Deck -

•Upper position 3" to 4½" (76 to 114mm) grass.

•Lower position 4½" to 6" (114 to 152mm) grass.

The rollers should be approximately ¼" /6.5 mm from ground. Do not adjust the rollers to support the deck.

IMPORTANT INFORMATION

The anti-scalp rollers must not be used for gauge wheels or the roller and deck may be damaged.

Cleaning and Washing

Regular cleaning and washing, especially under the mower deck, will increase the machine’s life-span. Make it a habit to clean the machine directly after use (after it is cooled), before the dirt sticks.

Do not spray water on the top of the mower deck. Use compressed air to clean the top side of mower deck. Regularly clean deck and underside of the deck with normal water pressure. Do not use a high pressure washer or steam cleaner. Avoid spraying engine and electrical components with water.

Do not rinse hot surfaces with cold water. Let unit cool before washing.

Use protective glasses when cleaning and washing.

Tunnel deck caster wheel

Combi deck caster wheel

8050-092

Clean regularly

English-20