10 – English
ASSEMBLY
Fit the blade
1 Start by removing any dirt from the contact surfaces on
the blade flange and blade.
2 Check the blade’s direction of rotation. The blade shall
rotate with the exposed part of the diamond in the
rotational direction of the blade. Since the blade rotation
direction can be selected, the water spray from the blade
can also be selected regardless of how the saw is turned
on the rail.
3 Screw together the outer blade flange, blade and blade
flange hub (tightening torque 70-80 Nm).
4 Hang the blade with the blade flange and blade flange hub
fitted on the cutting arm (blade is not shown in the figure).
5 Turn the blade flange hub carefully so that it slides into
one of the tracks in the pivot arm and lands in the correct
position to be screwed fast.
6 Press in the blade spindle into the cutting arm at the same
time as the blade is rotated carefully. When the blade
spindle can no longer be pressed in by hand it should be
tightened using the supplied 18-spanner until it is properly
secured (tightening torque 70-80 Nm).
Flush cutting
Screw off the outer blade flange and mount the blade on the
blade flange hub.
A=110 mm/4.33 inch, 6xM10
B=89 mm/3.5 inch, 6xM8
C=144 mm/5.7 inch
!
WARNING! Never mount or dismount the
blade or blade guard without first pulling out
the power cable running to the saw unit.
Carelessness can result in serious personal
injury or even death.
!
WARNING! Exercise care when assembling
the blade so that it does not risk becoming
loose when cutting. Carelessness can result
in serious personal injury or even death.