MAINTENANCE
Change the oil after every 25 hours of operation or at least once a year if the lawn mower is not used for 25 hours in one year. Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil plug securely each time you check the oil level.
TO CHANGE ENGINE OIL (See Fig. 12)
CAUTION: Petroleum solvents, such as kerosene, are not to be used to clean cartridge. They may cause deterioration of the cartridge. Do not oil cartridge. Do not use pressurized air to clean or dry cartridge.
4. Install cartridge, then replace cover.
CARTRIDGE SLOT
NOTE: Before tipping lawn mower to drain oil, empty fuel tank by running engine until fuel tank is empty.
1. Disconnect spark plug wire from spark plug and place |
wire where it cannot come in contact with plug. |
MUFFLER
COVER
FIG. 13
BACK PLATE
2. | Remove engine oil cap; lay aside on a clean surface. |
3. | Tip lawn mower on its side as shown and drain oil into |
| a suitable container. Rock lawn mower back and forth |
| to remove any oil trapped inside of engine. |
CONTAINER
FIG. 12
4.Wipe off any spilled oil from mower or side of engine.
5.Slowly pour oil down the oil fill spout, stopping every few ounces to check the oil level with the dipstick.
6.Stop adding oil when you reach the FULL mark on the dipstick. Wait a minute to allow oil to settle.
7.Continue adding small amounts of oil, rechecking the dipstick until oil level settles at FULL. DO NOT overfill, or engine will smoke heavily from the muffler on startup.
8.Always be sure to retighten dipstick before starting engine.
9.Reconnect spark plug wire to spark plug.
AIR FILTER (See Fig. 13)
Your engine will not run properly and may be damaged by using a dirty air filter. Replace the air filter every 100 hours of operation or every season, whichever occurs first. Service air cleaner more often under dusty conditions.
TO CLEAN AIR FILTER
1.Remove cover.
2.Carefully remove cartridge.
3.Clean by gently tapping on a flat surface. If very dirty,
replace cartridge. | 11 |
|
Inspect and replace corroded muffler as it could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in the “PRODUCT SPECIFIC ATIONS” section of this manual.
IN-LINE FUEL FILTER (See Fig. 14)
The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.
1.With engine cool, remove filter and plug fuel line sec- tions.
2.Place new fuel filter in position in fuel line with arrow pointing towards carburetor.
3.Be sure there are no fuel line leaks and clamps are properly positioned.
4.Immediately wipe up any spilled gasoline.
CLAMPCLAMP
FUEL
FILTER 
FIG. 14
CLEANING
IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
