Husqvarna YTH150 owner manual To Attach Front Bumper See Fig, Install Seat See Fig

ASSEMBLY

Use terminal access doors for:

•Inspection for secure connections (to tighten hard- ware).

•Inspection for corrosion.

•Testing battery.

•Jumping (if required).

•Periodic charging.

HEX NUT	LOCK	FLAT
	WASHER
		WASHER
DISCARD TERMINAL		HEX
PROTECTIVE CAPS
		BOLT

TO ATTACH FRONT BUMPER (See Fig. 4)

NOTE: For ease of assembly, you may wish to obtain the assistance of another person for mounting bumper to tractor.

• Press or tap the end caps into ends of bumper tube.

• The existing top screw and the existing front screw

must be removed from both sides.

• On both sides of chassis, position extension bracket as

shown and loosely assemble to rear chassis hole with

supplied 3/8-16 x 1-1/4 screw. Do not tighten the

brackets. Allow them to hang from the chassis.

• Position bumper and extension brackets so brackets

can be slid inside flattened ends of bumper.

• Slide bumper onto brackets and pivot upwards to align

center holes in extension brackets and tractor chassis.

TERMINAL ACCESS DOOR

POSITIVE

(RED)

CABLE

NEGATIVE (BLACK)

CABLE

• With holes aligned, install additional screws.

• Tighten all four (4) screws securely.

FRONT	TOP
	SCREW
SUSPENSION
BRACKET

FIG. 2

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob.

•Remove cardboard packing on seat pan.

•Place seat on seat pan and assemble shoulder bolt. Tighten shoulder bolt securely.

•Assemble adjustment knob and flat washer loosely. Do not tighten.

•Lower seat into operating position and sit on seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

SEAT PAN SEAT

SHOULDER

BOLT

FLAT WASHER ADJUSTMENT

KNOB

FIG. 3

BUMPER

EXTENSION

BRACKET

END CAP

Slide Bumper onto

Extension Brackets

and Pivot Upwards

FRONT SCREW

FIG. 4

TO ATTACH NOSE ROLLER (See Fig. 5)

•Position brackets, 17/32 x 7/8 x 16 gauge washers, and nose roller between deck mounting brackets as shown. Be sure to position brackets on correct side, as shown.

•Install 3/8-16 x 1 hex bolts and 3/8-16 crownlock nuts as shown. Tighten hardware securely.

NOTE: Be sure bracket tabs are positioned in tab holes in deck brackets.

TAB HOLE	“A” BRACKET TAB
NOSE ROLLER
HEX
BOLT
“B”	CROWNLOCK
	NUT
BRACKET
TAB	WASHER

7

FIG. 5