To Replace Motion Drive Belt See Fig | Husqvarna YTH2042 specification

SERVICE AND ADJUSTMENTS

TO REPLACE MOTION DRIVE BELT (See Fig. 25)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” in this section of manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Disconnect clutch wire harness (A).

•Remove anti-rotation link (B) on right side of tractor.

•Remove belt from stationary idler (C) and clutching idler (D).

•Remove belt from centerspan idler (E).

•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 26)

1.Park tractor on a level surface. Engage parking brake.

2.Lower attachment lift lever to its lowest position.

4.Remove any dirt or grass clippings which may have accumulated around mandrels and entire upper deck surface.

5.Remove belt from clutch pulley (M), both mandrel pul- leys (R) and all idler pulleys (S).

MOWER DRIVE BELT INSTALLATION

1.Install belt around both mandrel pulleys (R) and around idler pulleys (S) as shown.

2.Install belt onto clutch pulley (M).

IMPORTANT: Check belt for proper routing in all mower pulley grooves.

3. Raise attachment lift lever to highest position.

Q R

P

K

G MF

G

A E

B

C

LD

22

FIG. 26

Image 22

Husqvarna YTH2042 owner manual To Replace Motion Drive Belt See Fig, To Replace Mower Blade Drive Belt See Fig

Contents

917.287520 General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope Operation III. Children ServiceGeneral Service IV. Towing Table of Contents To Remove Tractor from Carton AssemblyUnassembled Parts Unpack Carton Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake System Operation Know Your Tractor Reverse Operation System ROS on Position HOW to USE Your Tractor System Characteristics To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate Mower To Operate on Hills Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL Level Purge Transmission To Start Engine See FigAutomatic Transmission Warm UP Mowing Tips General Recommendations MaintenanceMaintenance Schedule Brake Operation BatteryTractor Tires Engine Cleaning IN-LINE Fuel Filter See Fig To Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt Belt InstallationBelt Removal To Replace Motion Drive Belt See Fig To Replace Mower Blade Drive Belt See Fig Front Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Check Brake To Remove Wheel for Repairs See Fig To Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight Bulb Fuel System StorageOther Engine OIL Troubleshooting Points Problem Cause Correction Engine dies when Schematic Tractor Model NO. YTH2042 Wheels and Tires DecalsKEY Part Description Electrical KEY Part NO. NO. Description Chassis KEY Part Description Drive Tractor Model NO. YTH2042 Steering Assembly Mower Lift 9098 100 Engine Optional Equipment Engine Power Rating Information Mower Deck Tractor Model NO. YTH2042 Seat Assembly Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX 532 41 06-58 01.03.07 TH