CONTROLS
12. Cutting height pedal
The deck cutting height is obtained by pressing the foot pedal forward to lift the deck. To lower the deck, you apply pressure to the top side of the foot pedal and allow it to pivot while allowing the lift arm to rotate to the rear of the unit. To stop in a desired cutting position, rotate the foot pedal down into the notch in the height plate. The cutting height range is from 1 1/2" (38 mm) to 5" (127 mm) in 1/2" (13 mm) increments. The heights are measured from the ground up to the blade tip with the engine not running
.
IMPORTANT INFORMATION
In order to obtain an even cutting height it is important that the air pressure in all four tires is the same 15 psi (1 bar).
4 1/2
4
3 1/2
3
2 1/2
2
1 1/2
Cutting height pedal
Accessories
For mulching, there is a BioClip attachment available. This is mounted underneath the mower deck and concists of control plates and BioClip blades.
BioClip attachment
