Manuals / Husqvarna / Lawn and Garden / Lawn Mower

Husqvarna Z4822 manual Seat adjustment knobs, Fuses, Controls

Models: Z4822

1 74

Download 74 pages 46.77 Kb

Page 20

Image 20

CONTROLS

2. Seat adjustment knobs

The seat can be adjusted lengthways. When making adjustments, loosen the four knobs under the seat pan, after which the seat can be moved backward or forward. Do not forget to tighten the knobs.

3. Fuses

The fuses are located in the right front corner of the engine compartment. They are flat pin fuses of the same type used in automobiles.

There are two fuses.

Fuse ratings and functions:

•20 A, Primary fuse.

•7.5 A, Mower deck coupling.

CZ-1

Lengthways adjustment

8011-483

Fuses

English-18

Page 20

Image 20

Husqvarna Z4822 manual Seat adjustment knobs, Fuses, Controls

Contents

sure you understand the instructions before using the machine Operator´s manualZ4822/968999301 Z4824/968999303 EnglishPage Contents OPERATOR’S MANUAL RIDER Z SERIESEnglish-2 INTRODUCTION IntroductionCongratulations GeneralINTRODUCTION Good ServiceManufacturing Number SYMBOLS AND DECALS Symbols and DecalsXxxxxxx xxxx xxxxxxxx xxx Xxxxx xxxxxx xx xxxxxxxx xxxxx xxx xxxx xxxxxxSYMBOLS AND DECALS passengersCareful going other peopleGeneral Operation SAFETY INSTRUCTIONSSafety Instructions SAFETY INSTRUCTIONS Operate machine only in daylight or good artificial lightSAFETY INSTRUCTIONS Personal Safety EquipmentSlope Operation Children SAFETY INSTRUCTIONSMaintenance Safe Handling of GasolineThe engine and the exhaust system, become very hot during operation Risk for burns if touchedSAFETY INSTRUCTIONS General MaintenanceAlways use protective glasses when handling the battery English-13 SAFETY INSTRUCTIONSRisk of sparking SAFETY INSTRUCTIONS TransportIMPORTANT INFORMATION Customer responsibilities SAFETY INSTRUCTIONSControl Locations CONTROLSControls CONTROLS 1. Motion Control LeversTracking CONTROLS 2. Seat adjustment knobs3. Fuses 4. By pass linkages CONTROLS6. Blade switch see the safety rules5. Refueling CONTROLS7. Ignition Switch 8. Choke Control9. Throttle Control CONTROLS10. Hour Meter 11. Parking BrakeThe machine must be stopped before activating the parking brake CONTROLSAccessories 12. Cutting height pedalCONTROLS IMPORTANT INFORMATIONOPERATION OperationTraining To move forward and backwardOPERATION Before StartingStarting the Engine 4. Disengage the mower blades by depressing the blade switch OPERATIONOPERATION USE FULL THROTTLE WHEN MOWING no chokeIMPORTANT INFORMATION Do not run the starter for more than To start an engine with a weak battery To attach jumper cablesTo remove cables, reverse order OPERATIONThe mower deck’s anti-scalp rollers should be evenly adjusted Ensure that no one is near the machine when engaging the Blade switchRunning OPERATIONOperating on hills Do not drive up or down hills with slopes greater than10 degrees. And do not drive across any slopes OPERATIONMowing Tips OPERATIONIMPORTANT INFORMATION Stopping the EngineOPERATION No adjustments or maintenance to be carried out unless Moving by Handthe engine stopped the ignition key has removed the parking brake is onMaintenance Schedule MAINTENANCEMaintenance MAINTENANCE Check/adjust throttle cableBattery To clean battery and terminalsReplacing battery Always use two wrenches for the terminal screwsIgnition System Fitting the wrong spark plug type can damage the engineMAINTENANCE IMPORTANT INFORMATIONIMPORTANT INFORMATION Checking the Safety SystemMAINTENANCE Checking and Adjusting the Throttle Cable Checking the Engines Cooling Air IntakeMAINTENANCE Check and clean the cooling air intakeDo not use compressed air to clean the paper filter Replacing the Air FilterBriggs and Stratton engine Filters should not be oiled. They should be assembled dryFaulty adjustment can cause an accident Replacing the Fuel FilterChecking Tire Pressures Checking the Parking BrakeChecking the V-belts Deck beltDeck belt removal MAINTENANCE1. Clutch pulley Deck belt installationMAINTENANCE EZT belt To replace EZT E-Series Zeroturn Transaxle beltEZT belt removal MAINTENANCEBlade replacement Checking the BladesMAINTENANCE IMPORTANT INFORMATIONAdjusting the Mower Deck Before performing any service or adjustment checklist2. Place the Blade-switch in the disengaged position 3. Turn ignition switch to “OFF” position and remove the keyMAINTENANCE Side-to-side adjustmentTo level deck 5. Reinstall clevis pin and recheck dimension Front-to-back adjustment IMPORTANT INFORMATIONMAINTENANCE To adjust anti-scalp rollers Adjust Anti-scalp rollers with the mower on a flat level surfaceMAINTENANCE IMPORTANT INFORMATIONCleaning and Washing Use protective glasses when cleaning and washingCaster Wheels HardwareLUBRICATION LubricationLubrication Schedule GeneralLubricating the Cables Lubricating in Accordance with the Lubrication Schedule1. Caster wheels 2. Engine Oil Briggs & Stratton Changing the Engine OilAvoid skin contact wash with soap and water in case of spills LUBRICATION1. Place the machine on a flat surface IMPORTANT INFORMATIONLUBRICATION Checking the oil level2. Changing the Oil Filter Transmission LUBRICATION6. Check the oil level in the engine, fill if necessary. The oil filter holds 0.1 liters of oilTROUBLE SHOOTING GUIDE Trouble Shooting GuideProblem CauseTROUBLE SHOOTING GUIDE English-57TROUBLE SHOOTING GUIDE Uneven mowing resultsService STORAGEStorage Winter StorageWIRING DIAGRAMS Wiring diagramTECHNICAL DATA Technical DataZ4822 Z4824TECHNICAL DATA Z4822Z4824 EquipmentTorque Specifications TECHNICAL DATAAccessories Head lights BioClip attachment Mulch clip Collection systemUSA requirements CONFORMITY CERTIFICATESConformity Certificates SERVICE JOURNAL Service JournalDelivery Service Action1. Change engine oil After the First 5-8 HoursSERVICE JOURNAL 25-Hour Service SERVICE JOURNAL4. Check battery with cables 5. Check/clean the engine’s cooling air intake50-Hour Service SERVICE JOURNAL1. Perform the 25-hour service 5. Check/adjust the parking brake100-Hour Service SERVICE JOURNAL1. Perform the 25-hour service 2. Perform the 50-hour service 3. Change the engine oil filter 4. Clean/replace the spark plug300-Hour Service SERVICE JOURNALAction Date, mtr reading, stamp, signAt Least Once Each Year SERVICE JOURNALAction Date, mtr reading, stamp, sign112690Rir11/08/05