Rev. 0508
Maintenance
BEFORE SERVICING
ALWAYS DISCONNECT ELECTRICAL POWER AT THE MAIN DISCONNECT WHEN SERVICING OR REPLACING ANY ELECTRICAL COMPONENT.
This includes (but not limited to) Fans, Heaters Thermostats, and Lights.
Evaporator Fans
The evaporator fans are located at the center front of these merchandisers directly beneath the display pans.
Copper Coils
The copper coils used in Hussmann merchandisers may be repaired in the field. Materials are available from local refrigeration wholesalers.
Hussmann recommends using #15
Tips and Troubleshooting
Before calling for service, check the following:
1.Check electrical power supply to the equipment for connection.
2.Check fixture loading. Overstocking case will affect its proper operation.
Replacing Fluorescent Lamps
Fluorescent lamps are furnished with moisture resistant lamp holders, shields and end caps. Whenever a florescent lamp is replaced, be certain to reinstall the lamp shield and end caps over the lamp. The lamps supplied are single
3.If frost is collecting on fixture and/or product, check that Humidity Control is working properly, and that no outside doors or windows are open - allowing moisture to enter store.
RUR
ENCAPSULITE
SHATTERPROOF COATING - SA 10645
Complies with FDA USDA | NSF | |
& OSHA Regulations | ||
|
for replacement call:
Turn switch off then on after replacing bulb
FOR PROMPT SERVICE When contacting the factory,
be sure to have the Case Model and Serial Number handy. This information is on a plate located on the case itself.
Electrical Wiring Diagrams
| 3’ | W1400007 |
|
|
|
| 8’ | W1400009 |
|
|
|
Low / Medium Temp | 10’ | W1400015 |
|
|
|
| 11’ | W1400012 |
|
|
|
| 12’ | W1400016 |
|
|
|
| 4’ | W1400017 |
|
|
|
| 8’ | W1400005 |
|
|
|