Rev.0303
appearance and significantly shortening product shelf life. Soap and hot water are not enough to kill this bacteria. A sanitizing solution must be included with each cleaning process to eliminate this bacteria.
1.Scrub thoroughly, cleaning all surfaces, with soap and hot water.
2.Rinse with hot water, but do not flood.
3.Apply the sanitizing solution according to Hussmann’s directions.
4.Rinse thoroughly.
5.Dry completely before resuming operation.
CLEANING GLASS AND MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning any glass or mirrored components. Be sure to rinse and/ or dry completely.
Never use hot water on cold glass surfaces! It may shatter and cause serious injury! Allow glass
surfaces to warm first.
CLEANING PRECAUTIONS
WHEN CLEANING:
Do Not Use High Pressure Hoses
Do Not Introduce Water Faster than Waste Outlet can Drain
Never Use a Cleaning or Sanitizing Solution that has an OIL BASE (these will dissolve the butyl sealants) or AMMONIA BASE
(this will corrode the copper components of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
Do Use Water and a Mild Detergent for the Exterior Only!
Do Not Use Abrasives or Steel Wool Scouring Pads (these will mar the finish)
The high optical clarity of this glass is possible due to special coatings on the glass surface itself.To preserve this coating
and the optical clarity, keep the glass clean.
Windex® or Glass Plus® are the only solutions recommended for use in cleaning
In addition to cleaning the glass with the recommended product, there are precautions that should be taken when working and cleaning the inside of the case.
•When cleaning the inside of the cases,we recommend that the glass be fully opened and covered to prevent solutions from splashing onto the glass and ruining the coating on the inside.
PLEXIGLASS and ACRYLIC CARE
Improper cleaning not only accelerates the cleaning cycle but also degrades the quality of this surface. Normal daily buffing motions can generated static cling attracting dust to the surface.Incorrect cleaning agents or cleaning cloths can cause micro scratching of the surface,causing the plastic to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, or a paper towel marked as “dust and abrasive free” with 210® Plastic Cleaner and Polish available by calling Sumner Labs at
ANTISTATIC COATINGS
The 210® has proven to be very effective in not only cleaning and polishing the Plexiglass surface, but also providing antistatic and
15