Innovator Door Installation and

P/N 0425683F

Service Instruction

 

 

 

 

 

LAMP (END MULLION ) REPLACEMENT

1. Turn off lights at switch.

Switch

2.Pry the diffuser away from the end reflector, using a flat blade screwdriver. Pull the diffuser slightly upward and out of the bottom filler. The bottom filler does not have to be removed to replace the lamps. See Figure 21.

End Mullion

Lamp

!WARNING

Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component. This includes, but is not limited to, such items as doors, lights, fans, heaters, and thermostats.

4.Next, pull the lamp-holder off the lamp and pull the lamp out of the bottom lamp-holder.

5.Remove the tube guard from old lamp and place it on the new lamp.

6.Replace lamp by reversing the procedure. Ensure lamp pins line up with lamp-holder holes, and that lamp-holder is fully engaged in lamp- holder bracket.

BALLAST REPLACEMENT

Ballasts are located in the raceway below the door frame as shown in Figure 22. To access the raceway, remove the bumper, then remove the #8 hex head screws that hold on the front painted panel.

Figure 21.

Removing Diffuser from End Mullion Lamp

3.Pull the top lamp-holder out of the lamp-holder bracket.

Ballast

Figure 22. Ballast Location

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM

13