Innovator Door Installation and

P/N 0425683F

Service Instruction

 

 

 

 

 

!WARNING

Always disconnect the electrical power at the main disconnect when servicing or replacing any electrical component. This includes, but is not limited to, such items as doors, lights, fans, heaters, and thermostats.

LAMP (CENTER MULLION)

REPLACEMENT

Note: No additional parts need to be removed to change out the lamps

1. Turn off lights at switch.

2.Disengage the diffuser clips from the mullion by squeezing the diffuser cover at the clips. Two hands may be required as shown in Figure 19.

Diffuser Clip

Squeeze

Here

Light

Switch

Figure 19. Disengaging Diffuser Clips

Reach-in models manufactured with Innovator or Innovator II doors have anti-arc ballast. When re-starting lamps, turn power off then on.

3.Raise the diffuser slightly upward and out of the bottom filler. Twist the bottom of the diffuser toward the shelf and center of the door while lowering slightly to clear the honeycomb retainer. Pull the top of the diffuser toward the

HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A. • WWW.HUSSMANN.COM

11