1. Circuit breaker open or fuse blown | . |
2.Motor not plugged in.
3.Motor not switched on.
4.Motor thermal reset popped.
5.Too light or too long of an extension cord.
6.Pressure control knob loose or missing.
7.Spray tip plugged.
8.Spray tip worn out.
9.Gun handle filter plugged.
10.Paint hose plugged.
11.Loose fitting or hole in siphon hose.
12.Intake siphon hose plugged.
13.Siphon screen missing or plugged.
14.Sprayer under pressure when restarting.
15.Strainer bag plugging siphon screen.
UNLESS YOU ARE KNOWLEDGEABLE ABOUT THE REPAIR OF HIGH PRESSURE EQUIPMENT, DO NOT ATTEMPT TO REPAIR AN AIRLESS SPRAYER YOURSELF. ALWAYS FOLLOW ALL SAFETY PRECAUTIONS. THE H.E.R.O. SERVICE VIDEO TAPE
PRESSURE TEST
To verify the operation of an airless sprayer, use of pressure gauge is required. A pressure gauge (min. 3000 psi) installed at the gun, using a new .021 tip, and not less than 50 feet of H.E.R.O. airless spray hose is needed. If you do not have access to these items, your local H.E.R.O. authorized service center will be able to perform this test. Your model 1100NC is manufactured to perform at;
2650 psi
2250 psi
If your unit is unable to perform to the above pressure levels consult the troubleshooting guide for the required repair procedure.
TROUBLESHOOTING
DIAPHRAGM TEST
If your unit is disabled and you are unable to perform a pressure test, use the following procedures for determining the area to repair. This test will divide the two halves of the equipment (hydraulic from paint) and make identification of your solution easier to obtain. This test is commonly referred to as the
H.E.R.O. INDUSTRIES | 14 | 1100C & 1100NC OWNERS MANUAL |
