IBM 65E 4.2 - SERIAL PORTS AUX1 AND AUX2 (RJ45)

Connector Pin Assignments

________________________________________________________________

10 Installation Guide - Model 65E

b - AX3000 Connected to an Ethernet Controller

IMPORTANT: the cable is composed of two twisted pairs. The two wires

TX+ / TX- must belong to one pair and the two wires RX+ / RX- must

belong to the other pair.

4.2 - SERIAL PORTS AUX1 AND AUX2 (RJ45)

These serial ports are bi-directional ports (for printers, bar-code reader s, touch

screens, etc):

AUX1 and AUX2 connectors

(Model 65E rear panel)

Pin Signal Name Direction

1 RTS (Request To Send) Output

2 DTR (Data Terminal Ready) Output

3 RD (Received Data) Input

4 SG (Signal Ground) ---

5 CTS (Clear to Send) Input

6 TD (Transmitted Data) Output

7 --- ---

8 DCD (Data Carrier Detected) Input

Contents

Main Page Page Page 1 - SAFETY NOTICES 2 - INSTALLATION This chapter provides information and instructions to install the AX3000 Model 65E. 2.1 - DESCRIPTION 2.2 - INSTALLATION Page Page Page Page 3 - QUICK INSTALLATION This chapter describes the quick set-up procedure for the TCP/IP Platine terminal. TCP/IP AX3000 - User's Manual Page 4 - CONNECTOR PIN ASSIGNMENTS a - AX3000 Connected to a HUB 4.1 - ETHERNET PORT RJ45 (10BT) b - AX3000 Connected to an Ethernet Controller 4.2 - SERIAL PORTS AUX1 AND AUX2 (RJ45) Page 4.3 - KEYBOARD INTERFACE 4.4 - MOUSE INTERFACE 4.5 - VIDEO INTERFACE Connector Pin Assignments ________________________________________________________________ 14 Installation Guide - Model 65E 4.6 - PARALLEL INTERFACE The Platine terminal Model 65E is equipped with a parallel port. 5 - PROBLEM SOLVING