IBM manual 109

Set Startup Sequence

1.Power-off the computer.

2.Insert the backup copy of the Reference Diskette int the diskette drive.

3.Power-on the computer.

4. SelectSet		features	from		the		Main	Menu.
5. SelectSet startup sequence.					If you cannot set the
startup sequence,				replace			the	system	board.
6. Check the list of					devicesSet startupon the
sequence		screen.
7. Is the hard disk					drive in the list as a startup dev
Yes	Exit	from	this		screen and the Main Menu.
	Remove the backup copy of the Reference
	Diskette, and power-off the computer.
	Continue with			step		8.
No	Add	the	hard		disk	drive		as a	startup device.

8. Is an operating system installed?

Yes Go to step 10.

No Install the operating system.

9.After the operating system is installed, power-off the computer.

10. Power-on the computer.

Note: After the programs have been restored, the Diskette and F1 prompts appear, unless an operating system is present.

Restore		System	Partition
If	the	above	sequence does not correct the problem, do
the	following:

1.Power-off the computer.

2.Insert the backup copy of the Reference Diskette int the diskette drive.

3.Power-on the computer.

Note: If the I99900X5 error message appears, the power-on password has been set. To disable the power-on password (see “Power-On Password (700, 700C)” on page 97) before continuing with the next step.

4. SelectBackup/Restore system programs	from the
Main Menu, then selectRestore the System
Partition.

5.When the restore process completes,Set select

configuration , then selectRun automatic

	configuration.
6.	Power-off the computer and		remove	the	backup	copy
	of the	Reference Diskette	from	the	diskette	drive.
7.	Power-on	the computer.

98 IBM Mobile Systems HMM